LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Fusion S, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake Actuation >> Removal And Installation >> Brake Pedal and Bracket >> Removal and Installation

Removal and Installation

  1. Remove the brake booster push rod pin clip.
  2. Remove the brake booster push rod pin.
  3. Disconnect the stoplamp switch from the brake pedal bracket.
  4. Remove the 2 brake pedal bracket bolts.
    • To install, tighten to 23 Nm (17 lb-ft).
  5. Remove the 4 brake pedal bracket nuts and the brake pedal and bracket assembly.
    • To install, tighten to 23 Nm (17 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals