LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZXW SES, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 794 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Line Pressure Control Solenoid - Pc-A >> Installation

Line Pressure Control Solenoid - Pc-A: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the main control valve body.
    • Install the pressure control solenoid (PC-A) and install the (E) retaining clip.
    • Push the bulkhead connector through the solenoid body and twist the bulkhead connector, locking it into place.
    • Install the shift solenoid (SSPC-C) back into place and install the (E) retaining clip.
    • Connect the electrical connectors to the pressure control solenoid (PC-A) and the shift solenoid (SSPC-C).
    • Install the wire harness to solenoid body and tighten the bolts.
    2. Fig 1: Identifying Solenoid Body Electrical Wire Harness
    GF0006834Courtesy of FORD MOTOR CO.
  2. Install the solenoid body electrical connector O-ring seal, lubricate it with clean automatic transmission fluid.
    3. Fig 2: Locating Solenoid Body Electrical Connector O-Ring Seal
    G03889078Courtesy of FORD MOTOR CO.
  3. Install the transmission main control valve body. For additional information, refer to Solenoid Body Assembly  in this article.
scientia non olet · About LEMON Manuals