Removal and Installation

All vehicles

Remove the hydraulic control unit (HCU). For additional information, refer to VEHICLE DYNAMIC SYSTEMS .
Disconnect the speed control actuator electrical connector.
Remove the speed control actuator bolts and position the actuator aside.
- To install, tighten to 9 Nm (80 lb-in).

PZEV vehicles

Remove the evaporative emission canister purge valve. For additional information, refer to EVAPORATIVE EMISSIONS .

All vehicles

Disconnect the heater hose bracket pin-type retainer from the cowl.

Fig 1: Locating Heater Hose Bracket Pin-Type Retainer From Cowl
Courtesy of FORD MOTOR CO.
Remove the brake master cylinder. For additional information, refer to HYDRAULIC BRAKE ACTUATION .
Disconnect the electrical connectors and twist to remove the switches.
1. Speed control deactivation switch (if equipped).
2. Stop lamp switch.
3. Clutch pedal position (CPP) switch (manual transmission vehicles).
  
  Fig 2: Identifying Speed Control Deactivation Switch And Stop Lamp Switch
  Courtesy of FORD MOTOR CO.
Disconnect the brake booster actuating rod from the brake pedal.
1. Apply the brake pedal.
2. Disengage the tab.
3. Remove and discard the brake booster actuating rod pin.
  
  Fig 3: Removing And Discard Brake Booster Actuating Rod Pin
  Courtesy of FORD MOTOR CO.
Remove the brake booster retaining nuts.
- To install, tighten to 23 Nm (17 lb-ft).

CAUTION: Install a new brake booster actuating rod pin.

CAUTION: Make sure that the brake booster actuator rod is correctly positioned through the bulkhead rubber boot.

CAUTION: Make sure the brake booster gasket is correctly positioned on the brake booster before installation.

To install, reverse the removal procedure.
Bleed the brake system. For additional information, refer to BRAKE SYSTEM-GENERAL INFORMATION .