Pinpoint Test H: Fluid Leakage
- H1 INSPECT THE CLUTCH MASTER CYLINDER
- Inspect clutch master cylinder for leakage.
- Is the clutch master cylinder OK?
Yes : GO to H2.
No : REPAIR or INSTALL a new clutch master cylinder as necessary. REFER to CLUTCH CONTROLS .
- H2 INSPECT THE CLUTCH SLAVE CYLINDER
- Inspect clutch slave cylinder for leaks.
- Is the clutch slave cylinder OK?
Yes : GO to H3.
No : REPAIR or INSTALL a new clutch slave cylinder as necessary. REFER to CLUTCH CONTROLS .
- H3 INSPECT THE SYSTEM HYDRAULIC TUBES
- Inspect clutch hydraulic tubes for loose or damaged fittings causing leakage.
- Are the clutch hydraulic tubes OK?
Yes : Carry out a road test to VERIFY customer complaint.
No : REPAIR or INSTALL new components as necessary. TEST the clutch system for normal operation.