Pinpoint Test C: Clutch Drag
- C1 CHECK CLUTCH FLUID LEVEL
- Check clutch fluid level.
- Is the clutch fluid level between the MAX and MIN marks on the brake fluid reservoir?
Yes : GO to C2.
No : FILL reservoir to specification, CHECK the brake and clutch systems for leaks. TEST clutch system for normal operation.
- C2 TEST CLUTCH PEDAL FREE TRAVEL
- Operate clutch pedal manually to the point of resistance and release.
- Measure pedal travel.
- Is the measured dimension within 10 mm?
Yes : GO to C3.
No : GO to PINPOINT TEST B .
- C3 CHECK THE BELLEVILLE SPRING WASHER OF THE CLUTCH PRESSURE PLATE
- Remove transaxle.
- Does the clutch pressure plate or the Belleville spring washer of the clutch pressure plate show signs of wear or damage?
Yes : INSTALL a new clutch pressure plate. TEST the system for normal operation.
No : VERIFY the customer concerns. GO to SYMPTOM CHART if necessary.