Clutch Disc and Pressure Plate: Installation

Do not use cleaners with a petroleum base. Do not immerse the clutch pressure plate in solvent.

1. Position the clutch disc on the clutch pressure plate. Using a suitable clutch aligner, centralize the clutch disc to the clutch pressure plate.
   Fig 1: Centralizing Clutch Disc To Clutch Pressure Plate

   Courtesy of FORD MOTOR CO.
2. Using a suitable clutch aligner, position the clutch disc and clutch pressure plate on the flywheel. Install the 6 new clutch pressure plate-to-flywheel bolts.
   • Tighten the bolts evenly in a star pattern to 29 Nm (21 lb-ft).
     Fig 2: Locating Clutch Pressure Plate-To-Flywheel Bolts

     Courtesy of FORD MOTOR CO.
3. Remove the clutch aligner.
4. Install the transaxle. For additional information, refer to MANUAL TRANSAXLE-TRANSMISSION .