LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Removal And Installation >> Wheel Hub >> Removal

Wheel Hub: Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove and discard the dust cap.
    3. CAUTION: Do not use power tools to remove the wheel hub nut.
  3. With the weight of the vehicle on the wheel and tire assembly, loosen the wheel hub nut.

    4. Vehicles with rear brake discs 

    CAUTION: Care must be used when servicing rear brake components without disconnecting the parking brake cable from the brake caliper lever. Carefully position the caliper aside using a suitable support or damage to the parking brake cable end fittings can occur.
    CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
  4. Remove the brake caliper anchor plate bolts and position the caliper and anchor plate assembly aside.
    • Support the caliper and anchor plate assembly using mechanic's wire.
  5. Remove the brake disc.
  6. Remove and discard the wheel hub nut and remove the wheel hub and bearing assembly.

    7. Vehicles with rear drum brakes 

  7. Remove and discard the wheel hub nut and remove the brake drum and hub assembly.
scientia non olet · About LEMON Manuals