LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Removal And Installation >> Wheel Hub >> Installation

Wheel Hub: Installation

    Vehicles with rear drum brakes 

    CAUTION: Avoid any impact on the wheel speed sensor ring.
    CAUTION: Make sure the wheel speed sensor ring is clean.
    CAUTION: Avoid any contact between the wheel speed sensor ring and a magnetic surface.
    NOTE: Do not fully tighten the wheel hub retaining nut at this time.
  1. Position the brake drum and wheel hub assembly and install a new wheel hub nut.
    • Tighten until snug.
    2. CAUTION: Rotate the brake drum 10 times in the opposite direction when tightening the wheel hub nut to prevent damage to the bearing.
  2. Tighten the wheel hub retaining nut while rotating the brake drum in the opposite direction.
    • Tighten to 235 Nm (174 lb-ft).

    3. Vehicles with rear brake discs 

    CAUTION: Avoid any impact on the wheel speed sensor ring.
    CAUTION: Make sure the wheel speed sensor ring is clean.
    CAUTION: Avoid any contact between the wheel speed sensor ring and a magnetic surface.
    NOTE: Do not fully tighten the wheel hub retaining nut at this time.
  3. Position the wheel hub and bearing assembly and install a new wheel hub nut.
    • Tighten until snug.
    4. CAUTION: Rotate the wheel hub and bearing assembly 10 times in the opposite direction when tightening the wheel hub nut to prevent damage to the bearing.
  4. Position the brake disc on the wheel hub and tighten the wheel hub retaining nut while rotating the wheel hub in the opposite direction.
    • Tighten to 235 Nm (174 lb-ft).
  5. Position the brake caliper and anchor plate assembly and install the bolts.
    • Tighten to 55 Nm (41 lb-ft).

    6. All vehicles 

  6. Install a new dust cap.
scientia non olet · About LEMON Manuals