LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Removal And Installation >> Wheel Bearing - Drum Brakes >> Removal

Wheel Bearing - Drum Brakes: Removal

    All vehicles 

  1. Remove the brake drum and hub assembly. For additional information, refer to WHEEL HUB  in this article.

    2. Vehicles with anti-lock brakes 

  2. Remove and discard the wheel speed sensor ring.

    3. All vehicles 

  3. Remove and discard the water seal carrier and grease seal.
  4. Remove the snap ring.
  5. Using a press and suitable adapters, remove the wheel bearing.
    Fig 1: Removing Wheel Bearing
    G04651477Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals