Removal and Installation
CAUTION:
Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- Remove and discard the shock absorber lower bolt.
- To install, tighten to 103 Nm (76 lb-ft).
- Remove and discard the upper arm inboard bolt.
- To install, tighten to 115 Nm (85 lb-ft).
- Remove and discard the upper arm outboard bolt and remove the upper arm.
- To install, tighten to 115 Nm (85 lb-ft).
- To install, reverse the removal procedure.
NOTE:
Note the position of the upper arm to aid installation.
NOTE:
Position the shock absorber as necessary to remove the upper arm.
CAUTION:
Tighten the upper arm bolts with the suspension at curb height.