LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Removal And Installation >> Stabilizer Bar >> Installation

Stabilizer Bar: Installation

    CAUTION: Do not use any lubrication on the stabilizer bar or the bushings.
    CAUTION: The stabilizer bar bushings must be located correctly on the stabilizer bar. The protrusion on both bushings must be facing the LH side of the vehicle for correct installation.
    Fig 1: Installing Bushings Onto Stabilizer Bar
    G04651496Courtesy of FORD MOTOR CO.
  1. If necessary, install the bushings onto the stabilizer bar.
    2. NOTE: Apply water to the brackets to aid in installation.
  2. Position the stabilizer bar and brackets and install the bolts.
    • Tighten to 55 Nm (41 lb-ft).
  3. Position the stabilizer bar links and spacers and install the nut and bushings.
    • Tighten to 15 Nm (11 lb-ft).
scientia non olet · About LEMON Manuals