Lower Arm - Rear: Installation
- Position the rear lower arm and install the cam bolt, cam adjuster and nut.
- Tighten the nut until snug.
- Install the spring. For additional information, refer to SPRING in this article.
- Tighten the rearward lower arm-to-crossmember nut to 90 Nm (66 lb-ft).
- Check and, if necessary, adjust the rear toe. For additional information, refer to SUSPENSION SYSTEM-GENERAL INFORMATION .
NOTE:
Align the mark on the rearward lower arm adjustment cam to the mark on the crossmember.
NOTE:
Do not fully tighten the rearward lower arm-to-crossmember nut at this time.
NOTE:
Final tightening of the rear suspension components should be carried out with the suspension at curb height.