LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Pump Pulley >> Removal

Power Steering Pump Pulley: Removal

CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants, or premature failure of the power steering components can result.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the 2 bolts and remove the accessory drive belt splash shield.
  3. Rotate the accessory drive belt tensioner clockwise and position the accessory drive belt away from the power steering pump pulley.
  4. Disconnect the power steering pressure (PSP) switch electrical connector.
  5. Using the special tool, remove the power steering pump pulley.
    Fig 1: Removing Power Steering Pump Pulley
    G04651738Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals