LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Pump Pulley >> Installation

Power Steering Pump Pulley: Installation

    NOTE: Make sure the pulley is flush with the end of the power steering pump shaft.
    Fig 1: Installing Power Steering Pump Pulley
    G04651739Courtesy of FORD MOTOR CO.
  1. Using the special tool, install the power steering pump pulley.
  2. Rotate the tensioner clockwise and position the accessory drive belt on the power steering pump pulley.
  3. Position the accessory drive belt splash shield and install the 2 bolts.
    • Tighten to 9 Nm (80 lb-in).
scientia non olet · About LEMON Manuals