LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Restraints >> Seat Belts >> Safety Belt System >> Removal And Installation >> Safety Belt Buckle - Rear >> Removal and Installation

Removal and Installation

WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS] if equipped, buckles, shoulder belt height adjusters [if equipped] child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of injury in collisions.

    All seats 

  1. Lift the rear seat cushion.

    2. LH buckle 

  2. The LH safety belt buckle is a part of the rear center safety belt retractor assembly. For removal information refer to SAFETY BELT RETRACTOR - REAR, CENTER, 3-DOOR/5-DOOR/WAGON  or SAFETY BELT RETRACTOR - REAR, CENTER, 4-DOOR  in this article.

    3. RH and center buckle 

  3. Remove the bolt and the safety belt buckle assembly.
    • To install, tighten to 55 Nm (41 lb-ft).

    4. All seats 

    NOTE: Make sure the safety belt buckle is correctly positioned on the locator dowel.
  4. To install reverse the removal procedure.
  5. Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM  in this article.
scientia non olet · About LEMON Manuals