Removal and Installation

NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of contamination from a failed A/C compressor or damage to the suction accumulator.

Remove the A/C compressor. For additional information, refer to AIR CONDITIONING (A/C) COMPRESSOR in this article.
Remove the lower radiator air deflector.
Disconnect the fitting at the accumulator.
- Discard the O-ring seal.
- To install, tighten to 8 Nm (71 lb-in).
  
  Fig 1: Locating Accumulator Fitting
  Courtesy of FORD MOTOR CO.
Disconnect the fitting at the condenser.
- Discard the O-ring seal.
- To install, tighten to 8 Nm (71 lb-in).
  
  Fig 2: Locating Condenser Fitting
  Courtesy of FORD MOTOR CO.
Remove the compressor manifold and tube assembly.
To install, reverse the removal procedure.
- Lubricate the refrigerant system with the correct amount of clean PAG oil. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION AND DIAGNOSIS .