Transmission Fluid Cooler Tubes - 2.0L: Removal
WARNING: This page is about a different variant/trim than selected.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- Disconnect the fluid cooler tubes from the transmission fluid cooler.
- Push the connector fitting into the cooler line.
- Press the tab release button.
- Pull the connector fitting off the cooler line.
- Disconnect the transaxle fluid cooler tubes from the transaxle.
- Remove the transaxle fluid cooler tubes from the vehicle.
NOTE:
Take notice of retaining ring color for correct orientation at installation.
NOTE:
Do not remove the fluid tube adapter from the transaxle housing.