LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission External Controls System) >> Removal And Installation >> Selector Lever Knob >> Removal

Selector Lever Knob: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
    2. NOTE: Selector lever assembly shown removed.
    Fig 1: Locating Overdrive (O/D) Switch Electrical Connector
    G04653255Courtesy of FORD MOTOR CO.
  2. Disconnect the overdrive (O/D) switch electrical connector.
  3. Remove the selector lever knob.
    • Remove and discard the screw.
    • Pull off the knob.
      Fig 2: Locating Selector Lever Knob And Screw
      G04653256Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals