Halfshaft Seal - RH: Removal

WARNING: This page is about a different variant/trim than selected.

Loosen the strut and spring assembly top mount nuts by 5 turns.

Fig 1: Locating Strut And Spring Assembly Mount Nuts
Courtesy of FORD MOTOR CO.
Detach the lower arm from the wheel knuckle.

Fig 2: Locating Lower Arm
Courtesy of FORD MOTOR CO.
Remove and discard the center bearing cap and locknuts.

Fig 3: Locating Center Bearing Cap And Locknuts
Courtesy of FORD MOTOR CO.
Detach the halfshaft from the transaxle and secure it to one side.
- Allow the oil to drain into a suitable container.
  
  Fig 4: Removing Halfshaft From Transaxle
  Courtesy of FORD MOTOR CO.
Remove the halfshaft seal.