Before Pinpoint Tests

WARNING: This page is about a different variant/trim than selected.

NOTE: Before entering pinpoint tests, check the powertrain control module wiring harness for correct connections, bent or broken pins, corrosion, loose wires, correct routing, correct seals and their condition. Check the PCM, sensors and actuators for damage. Refer to the INTRODUCTION - GASOLINE .

NOTE: If a concern still exists after electrical diagnosis, refer to DIAGNOSIS BY SYMPTOM in this article.

If DTCs appear while carrying out the on-board diagnostics, refer to DIAGNOSTIC TROUBLE CODE (DTC) CHARTS for the appropriate repair procedure. Prior to entering pinpoint tests, refer to any TSBs for transaxle concerns.