LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission) >> Diagnosis And Testing >> Transaxle Drive Cycle Test >> After On-Board Diagnostics

After On-Board Diagnostics

WARNING: This page is about a different variant/trim than selected.
NOTE: The vehicle wiring harness, powertrain control module and non-transaxle sensors may affect transaxle operations. Repair these concerns first.

After the on-board diagnostic procedures are completed, repair all DTCs.

Begin with non-transaxle related DTCs, then repair any transaxle related DTCs. Refer to DIAGNOSTIC TROUBLE CODE (DTC) CHARTS  for information on condition and symptoms. This chart will be helpful in referring to the correct article(s) and aids in diagnosing internal transaxle concerns and external non-transaxle inputs. The pinpoint tests are used in diagnosing transaxle electrical concerns. Make sure that the vehicle wiring harness and the PCM are diagnosed as well. The INTRODUCTION - GASOLINE will aid in diagnosing non-transaxle electronic components.

scientia non olet · About LEMON Manuals