Other Concerns: Slips/Chatters In 2nd Gear

WARNING: This page is about a different variant/trim than selected.

OTHER CONCERNS: SLIPS/CHATTERS IN 2ND GEAR

Possible Component	Reference/Action
264 - ELECTRICAL ROUTINE
Powertrain Control System
PCM, vehicle wiring harnesses and SSD.	Carry out on-board diagnostic tests. Refer to the INTRODUCTION - GASOLINE for diagnosis and testing of the PCM. GO to PINPOINT TEST A . Clear the DTCs, road test and rerun on-board diagnostic test.
364 - HYDRAULIC/MECHANICAL ROUTINE
Fluid
Incorrect level.	Adjust to correct level. Refer to PRELIMINARY INSPECTION in this article.
Condition.	Carry out Fluid Condition Check. Refer to PRELIMINARY INSPECTION in this article.
Incorrect Pressures
High/low pressures.	Check pressure at line tap. Carry out Line Pressure Test. Refer to SPECIAL TESTING PROCEDURES in this article.
Fluid Pump Assembly
Bolts not tightened to specification.	Tighten to specifications.
Gasket damaged.	Inspect for damage. If damaged, repair as necessary.
Porosity, cross leaks, plugged hole.	Inspect for damage. If damaged, repair as necessary.
Servo
Seals (piston and cover) damaged.	Inspect for damage. Repair as necessary.
Band
Band damaged.	Inspect for damage. Repair as necessary.
Servo worn or damaged.	Inspect for damage. If damaged, repair as necessary.
Not adjusted correctly.	Adjust correctly.
Anchor bolt damaged or worn.	Inspect for damage. If damaged, repair as necessary.
OD Planetary Assembly
Planetary damaged.	Inspect for damage. If damaged, repair as necessary.
Forward Clutch Assembly
Seals, piston damaged.	Inspect for damage. Repair as necessary.
Check balance dam.	Inspect for damage. If damaged, repair as necessary.
Friction elements damaged or worn.	Inspect for damage. If damaged, repair as necessary.
Return springs damaged.	Inspect for damage. If damaged, repair as necessary.