LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Other Concerns: Slips/Chatters In 1st Gear

Other Concerns: Slips/Chatters In 1st Gear

WARNING: This page is about a different variant/trim than selected.
OTHER CONCERNS: SLIPS/CHATTERS IN 1ST GEAR

Possible Component Reference/Action
263 - ELECTRICAL ROUTINE 
Powertrain Control System   
  • PCM, vehicle wiring harnesses and SSC.
  • Carry out on-board diagnostic tests. Refer to the INTRODUCTION - GASOLINE for diagnosis and testing of the PCM.
  • GO to PINPOINT TEST A .
  • Repair as required. Clear the DTCs, road test and rerun on-board diagnostic test.
363 - HYDRAULIC/MECHANICAL ROUTINE 
Fluid   
  • Incorrect level.
  • Condition.
Incorrect Pressures   
  • High/low pressures.
Main Control   
  • Bolts not tightened to specification.
  • Tighten to specifications.
  • Separator plate damaged.
  • Inspect for damage. If damaged, repair as necessary.
  • Contamination.
  • Disassemble and clean.
  • Valves/springs damaged, misassembled, missing, stuck, or bore damaged.
  • If damaged or parts are missing, install a new main control assembly. If misassembled, reassemble correctly. DO NOT stone, file or sand valves. This will remove the anodized finish and may result in further main control or transaxle damage.
Fluid Pump Assembly   
  • Bolts not tightened to specification.
  • Tighten to specifications.
  • Gasket damaged.
  • Inspect for damage. If damaged, repair as necessary.
  • Porosity, cross leaks, plugged hole.
  • Inspect for damage. If damaged, repair as necessary.
Forward Clutch Assembly   
  • Seals, piston damaged.
  • Inspect for damage. Repair as necessary.
  • Check balance dam.
  • Inspect for damage. If damaged, repair as necessary.
  • Friction elements damaged or worn.
  • Inspect for damage. If damaged, repair as necessary.
  • Return springs damaged.
  • Inspect for damage. If damaged, repair as necessary.
Low One-Way Clutch   
  • Worn, damaged or assembled incorrectly.
  • Inspect for damage. Repair as necessary.