LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Other Concerns: Noise/Vibration - Forward Or Reverse

Other Concerns: Noise/Vibration - Forward Or Reverse

WARNING: This page is about a different variant/trim than selected.
OTHER CONCERNS: NOISE/VIBRATION - FORWARD OR REVERSE

Possible Component Reference/Action
254 - ELECTRICAL ROUTINE 
Powertrain Control System   
  • PCM, vehicle wiring harnesses, SSA, SSB, SSC, SSD, SSE and PCA.
  • Carry out on-board diagnostic tests. Refer to the INTRODUCTION - GASOLINE for diagnosis and testing of the PCM.
  • GO to PINPOINT TEST A .
  • Repair as required. Clear the DTCs, road test and rerun on-board diagnostic test.
354 - HYDRAULIC/MECHANICAL ROUTINE 
Fluid Pump Assembly   
  • Bolts not tightened to specification.
  • Tighten to specifications.
  • Gasket damaged.
  • Inspect for damage. If damaged, repair as necessary.
  • Porosity, cross leaks, plugged hole.
  • Inspect for damage. If damaged, repair as necessary.
Flex Plate or Adapter Plate   
  • Damaged.
  • Inspect for damage. Repair as necessary.
  • Adapter plate not aligned correctly.
  • Remove the transaxle. Align the adapter plate.