Other Concerns: Fluid Venting Or Foaming

WARNING: This page is about a different variant/trim than selected.

OTHER CONCERNS: FLUID VENTING OR FOAMING

Possible Component	Reference/Action
261 - ELECTRICAL ROUTINE
Powertrain Control System
No electrical concerns.
361 - HYDRAULIC/MECHANICAL ROUTINE
Fluid
Incorrect level.	Adjust to correct level. Refer to PRELIMINARY INSPECTION in this article.
Condition.	Carry out Fluid Condition Check. Refer to PRELIMINARY INSPECTION in this article.
Fluid Pump Assembly
Bolts not tightened to specification.	Tighten to specifications.
Gasket damaged.	Inspect for damage. If damaged, repair as necessary.
Porosity, cross leaks, plugged hole.	Inspect for damage. If damaged, repair as necessary.
Case
Cap not seated	Instal the vent cap past the second stop.
Case vent damaged.	Inspect for damage. If damaged, repair as necessary.
Other
Transaxle overheating.	Refer to Routine 257/357 in this article.
Water in transaxle	Inspect the transmission fluid level indicator handle and seal. Install a new indicator if damage is indicated.
Vent cap	Inspect for foreign material in cap, clean as necessary