Engagement Concerns: Harsh Forward And Reverse

WARNING: This page is about a different variant/trim than selected.

ENGAGEMENT CONCERNS: HARSH FORWARD AND REVERSE

Possible Component	Reference/Action
208 - ELECTRICAL ROUTINE
Powertrain Control System
PCM, vehicle wiring harnesses, TR sensor, transmission fluid temperature (TFT) sensor, SSC, and SSD.	Carry out on-board diagnostic tests. Refer to the INTRODUCTION - GASOLINE for diagnosis and testing of the PCM. GO to PINPOINT TEST A , GO to PINPOINT TEST B and GO to PINPOINT TEST C . Repair as required. Clear the DTCs, road test and rerun on-board diagnostic test.
308 - HYDRAULIC/MECHANICAL ROUTINE
Fluid
Incorrect level.	Adjust to correct level. Refer to PRELIMINARY INSPECTION in this article.
Condition.	Carry out Fluid Condition Check. Refer to PRELIMINARY INSPECTION in this article.
Incorrect Pressures
High pressures.	Check pressure at line tap. Carry out Line Pressure Test. Refer to SPECIAL TESTING PROCEDURES in this article.
Main Control
Bolts not tightened to specification.	Tighten to specifications.
Separator plate damaged.	Inspect for damage. If damaged, repair as necessary.
Contamination.	Disassemble and clean.
Valves/springs damaged, misassembled, missing, stuck, or bore damaged.	If damaged or parts are missing, install a new main control assembly. If misassembled, reassemble correctly. DO NOT stone, file or sand valves. This will remove the anodized finish and may result in further main control or transaxle damage.
Forward Clutch Assembly
Seals, piston damaged.	Inspect for damage. Repair as necessary.
Friction elements damaged or worn.	Inspect for damage. Repair as necessary.
Return springs damaged.	Inspect for damage. Repair as necessary.
Reverse and Low/Reverse Clutch Assembly
Seals, piston damaged.	Inspect for damage. Repair as necessary.
Check balance dam.	Inspect for damage. Repair as necessary.
Friction elements damaged or worn.	Inspect for damage. Repair as necessary.
Return springs damaged.	Inspect for damage. Repair as necessary.
One-way clutch	Inspect for damage. Repair as necessary.