LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Engagement Concern: No Forward In O/D Only

Engagement Concern: No Forward In O/D Only

WARNING: This page is about a different variant/trim than selected.
ENGAGEMENT CONCERN: NO FORWARD IN O/D ONLY

Possible Component Reference/Action
201A - ELECTRICAL ROUTINE 
Powertrain Control System   
  • Powertrain control module (PCM), vehicle wiring harness, shift solenoid (SSC) (off = low).
  • Carry out on-board diagnostic tests. Refer to the INTRODUCTION - GASOLINE for diagnosis and testing of the PCM.
  • GO to PINPOINT TEST A .
  • Repair as required. Clear the DTCs, road test and rerun on-board diagnostic test.
301A - HYDRAULIC/MECHANICAL ROUTINE 
Fluid   
  • Incorrect level
  • Condition
Forward Clutch Assembly   
  • Seals, piston damaged
  • Inspect for damage. Repair as necessary.
  • Check balance dam.
  • Inspect for damage. Repair as necessary.
  • Friction elements damaged or worn.
  • Inspect for damage. Repair as necessary.
  • Return springs damaged.
  • Inspect for damage. Repair as necessary.
Servo   
  • Seals (piston and cover) damaged.
  • Inspect for damage. Repair as necessary.
Band   
  • Band damaged.
  • Inspect for damage. Repair as necessary.
  • Servo worn or damaged.
  • Inspect for damage. Repair as necessary.
  • Not adjusted correctly.
  • Adjust correctly
  • Anchor bolt damaged or worn.
  • Inspect for damage. Repair as necessary.
Case   
  • Damaged.
  • Inspect for damage. Repair as necessary.