Overdrive Servo: Installation
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Install the return spring and the intermediate overdrive servo piston.
- Install the servo cover cap.
- Install the special tool.
- Tighten the special tool bolt.
- Install the servo cover retaining ring.
- Loosen the special tool bolt.
- When the spring tension is released, remove the special tool.
- Install the transmission fluid cooler tube and bolt.
- Tighten to 25 Nm (18 lb-ft).
- Install the LH splash shield and the 7 retainers.
- Tighten to 10 Nm (89 lb-in).
- Start the vehicle. Place the transmission range selector lever in each gear and allow to engage. Check for leaks.
- Check the transmission fluid.
CAUTION:
Do not use a screwdriver to install the retaining ring or damage to the case may occur. Use only snap ring pliers to install the retaining ring.
CAUTION:
If the case is stamped "WG", install a wide-groove snap ring, or the servo will be damaged.
NOTE:
The WG stamp is located on the case toward the passenger side of the overdrive servo. The letters WG are etched into the case and hard to see.
NOTE:
If the servo cover will not seat deep enough in the bore to install the servo cover retaining ring, use a blunt punch or small hammer and gently tap the cover around the outer edge until the servo cover retaining ring can be installed.