LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Parking Brake System And Actuation) >> Removal And Installation >> Parking Brake Cable - Front >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the parking brake control. For additional information, refer to Parking Brake Control .
  3. Disconnect the front parking brake cable from the equalizer bracket by compressing the cable conduit locking tabs.
    4. Fig 1: Front Parking Brake Cable At Equalizer Bracket
    GF0024653Courtesy of FORD MOTOR CO.
  4. Release the front parking brake cable pass-through grommet from the vehicle underbody.
  5. Remove the front parking brake cable by pulling the front parking brake cable through the equalizer bracket.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals