LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 935 (Instrument Panel And Console) >> Removal And Installation >> Instrument Panel Center Finish Panel >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Lower the glove compartment.
    • Press the glove compartment release tabs inward while pulling downward on the glove compartment.
    3. Fig 1: Glove Compartment Release Tabs
    GF0023786Courtesy of FORD MOTOR CO.
  3. Disconnect the temperature control cable from the blend door shaft.
    • Using the special tool, align the locator holes.
    • Release the locking tab.
    • Disconnect the temperature control cable.
    4. Fig 2: Disconnecting Temperature Control Cable From Blend Door Shaft
    GF0023787Courtesy of FORD MOTOR CO.
  4. Remove the instrument panel center finish panel.
    • Disconnect the electrical connectors.
    5. Fig 3: Instrument Panel Center Finish Panel
    GF0023788Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals