Front Toe Adjustment

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Start the engine and center the steering wheel.
Turn the engine off. Hold the steering wheel in the straight-ahead position using a suitable holding device.
Check the toe settings following the equipment manufacturer's instructions.

NOTE: Do not allow the steering gear bellows to twist when the front wheel spindle tie-rod is rotated.

Remove the steering gear bellows clamp(s).

Fig 1: Steering Gear Bellows Clamp

Courtesy of FORD MOTOR CO.

Loosen the tie-rod end jam nut(s).
- Clean and lubricate the nut(s) and front wheel spindle tie-rod threads.

Fig 2: Tie-Rod End Jam Nut

Courtesy of FORD MOTOR CO.

Rotate the front wheel spindle tie-rods to increase or decrease the front toe.

Fig 3: Rotating Front Wheel Spindle Tie-Rod

Courtesy of FORD MOTOR CO.

CAUTION: Hold the tie-rod end stationary with a wrench while tightening the nut, or damage to the boot can occur.

NOTE: Do not disturb the toe settings while tightening the nut(s).

Tighten the tie-rod end jam nut(s) to 40 Nm (30 lb-ft).

Fig 4: Tie-Rod End Jam Nut

Courtesy of FORD MOTOR CO.

Install the steering gear bellows clamp(s).

Fig 5: Steering Gear Bellows Clamp

Courtesy of FORD MOTOR CO.

Check the toe settings. Follow the equipment manufacturer's instructions.