Transaxle Support Insulator - Lower, Front: Removal

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the LH splash shield.

Fig 1: Locating LH Splash Shield

Courtesy of FORD MOTOR CO.

Remove the 7 retainers and the LH splash shield.

Fig 2: View Of LH Splash Shield And Retainers

Courtesy of FORD MOTOR CO.

Remove the 4 bolts and the cross brace.

Fig 3: Locating Cross Brace & Bolts

Courtesy of FORD MOTOR CO.

Remove the bolt for the mount and the 2 bolts for the brace.

Fig 4: Identifying Front Roll Restrictor Bolt & Bolts For Engine Support Crossmember

Courtesy of FORD MOTOR CO.

Remove the rear bolt and remove the brace.

Fig 5: Identifying Cross Brace And Rear Nut

Courtesy of FORD MOTOR CO.

Remove the 2 bolts from the mount and remove the mount.