Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Output Shaft Speed OSS Sensor With Torque Specifications

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	-	Output shaft speed (OSS) electrical connector
2	-	OSS sensor bolt
3	-	OSS sensor

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the 7 retainers and the LH splash shield.
- To install, tighten to 10 Nm (89 lb-in).

Fig 2: View Of LH Splash Shield And Retainers

Courtesy of FORD MOTOR CO.

Remove the output shaft speed (OSS) sensor
1. Disconnect the OSS electrical connector.
2. Remove the OSS sensor bolt.
3. Remove the OSS sensor.
4. To install, tighten to 12 Nm (9 lb-ft).

Fig 3: Identifying Output Shaft Speed (OSS) Sensor

Courtesy of FORD MOTOR CO.

NOTE: When installing the sensor, lubricate the O-ring seal with clean transmission fluid.

Inspect the O-ring seal for nicks or cuts. Install a new O-ring seal as necessary.

Fig 4: Output Shaft Speed (OSS) Sensor O-Ring

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.