Torque Converter Housing: Assembly

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Position a new differential lube tube in the torque converter housing.

Fig 1: Differential Lube Tube

Courtesy of FORD MOTOR CO.

Using the special tool, install the differential lube tube.

Fig 2: Installing Differential Lube Tube Using Special Tools

Courtesy of FORD MOTOR CO.

Install the differential lube tube bolt.
- Tighten to 13 Nm (10 lb-ft).

Fig 3: Differential Lube Tube Bolt

Courtesy of FORD MOTOR CO.

NOTE: The final drive ring gear is installed with the lug end up.

Install the final drive ring gear.

Fig 4: Final Drive Ring Gear

Courtesy of FORD MOTOR CO.

Install the final drive ring gear retaining ring.

Fig 5: Final Drive Ring Gear Retaining Ring

Courtesy of FORD MOTOR CO.

Install the cooler tube fitting.
- Tighten to 48 Nm (35 lb-ft).

Fig 6: Cooler Tube Fitting

Courtesy of FORD MOTOR CO.