LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Camshaft Roller Follower >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the LH and RH valve covers. For additional information, refer to Valve Cover - LH  and Valve Cover - RH .
    3. CAUTION: Only use hand tools when removing or installing the spark plugs or damage may occur to the cylinder head or spark plug.
  3. Remove the 6 spark plugs.
    • To install, tighten to 15 Nm (11 lb-ft).
  4. Remove the RH splash shield.
    • To install, tighten to 9 Nm (80 lb-in).
  5. Rotate the crankshaft until the camshaft lobe is pointing directly away from the roller follower.
  6. Using the special tool, remove the roller followers.
    7. Fig 1: Removing Roller Using Special Tool (303-473)
    GF0024250Courtesy of FORD MOTOR CO.
    NOTE: Lubricate the camshaft followers with clean engine oil.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals