LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 871 (Front Suspension) >> Removal And Installation >> Stabilizer Bar Bushing >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When installing the stabilizer bar bushings, make sure the bushings are correctly oriented with the bushing flanges in the up position and the bushing split pointing to the front of the vehicle.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the 2 bolts and the stabilizer bar bushing bracket.
    • To install, tighten to 70 Nm (52 lb-ft).
    3. NOTE: Inspect the stabilizer bar bushing for wear. If necessary, install a new part.
  3. Remove the stabilizer bar bushing.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals