LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 867 (Rear Drive Axle/Differential) >> In-Vehicle Servicing >> Stub Shaft Pilot Bearing and Seal >> Installation

Stub Shaft Pilot Bearing and Seal: Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the new stub shaft pilot bearing with rear axle lubricant.
  1. To install the bearing, use the special tools and install the stub shaft pilot bearing.
    2. Fig 1: Installing Stub Shaft Pilot Bearing
    GF0024593Courtesy of FORD MOTOR CO.
    NOTE: Lubricate the new stub shaft pilot bearing housing seal with grease.
  2. Using the special tools, install the stub shaft pilot bearing housing seal.
    3. Fig 2: Installing Stub Shaft Pilot Bearing Housing Seal
    GF0024594Courtesy of FORD MOTOR CO.
    CAUTION: Inspect the inboard CV joint seal journal for rust or nicks/scratches prior to installing the halfshaft. If necessary, polish the seal journal with fine crocus cloth.
  3. Install the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS article.
scientia non olet · About LEMON Manuals