LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 865 (Windows And Glass) >> Removal And Installation >> Window Glass - Front Door >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Remove the screw and the door trim panel bracket.
  3. Position the watershield aside.
  4. Remove the interior door glass weatherstrip.
  5. Connect the window control switch electrical connector.
  6. Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  7. Using the window control switch, lower the front door window glass to gain access to the front door window glass screws.
  8. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  9. Disconnect the window control switch electrical connector.
  10. Remove the 2 front door window glass screws.
    • To install, tighten to 5 Nm (44 lb-in).
    11. Fig 1: Front Door Window Glass Screws
    GF0023775Courtesy of FORD MOTOR CO.
  11. Remove the front door window glass.
  12. To install, reverse the removal procedure.
    • Cycle the front door window glass to make sure it is engaged correctly.
scientia non olet · About LEMON Manuals