LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 842 (Fuel Tank And Fuel Lines - F250-F550) >> Removal And Installation >> Fuel Lines - Gasoline Engines >> Removal And Installation >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  3. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.


  1. Disconnect the fuel supply tube spring lock coupling at the fuel rail. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  2. Disconnect the fuel vapor tube quick connect coupling at the evaporative emissions (EVAP) canister purge valve. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  3. Disconnect the fuel supply tube and the fuel vapor tube from the position retainer at the rear of the engine.
  4. Disconnect the fuel supply tube quick connect coupling at the fuel filter inlet. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  5. Disconnect the fuel supply tube quick connect coupling at the fuel filter outlet. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL article.
  6. Disconnect the fuel supply tubes from the position retainers.
  7. Remove the fuel supply tubes.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals