LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 820 (Instrument Panel And Console F250-F550)) >> Removal And Installation >> Instrument Panel Center Finish Panel >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument cluster finish panel. For additional information, refer to Instrument Cluster Finish Panel  in this article.
  2. Remove the screws and the utility hook or if equipped, remove the dual fuel bezel.
    • If equipped with the dual fuel switch bezel, disconnect the electrical connector.
    Fig 1: Locating Dual Fuel Switch Bezel Screws
    GF0005261Courtesy of FORD MOTOR CO.
    3. NOTE: Open the ashtray/beverage holder to gain access to the lower beverage holder screws.
    Fig 2: Locating Lower Ashtray/Beverage Holder Screws
    GF0005262Courtesy of FORD MOTOR CO.
  3. Remove the lower ashtray/beverage holder screws.
  4. Remove the ashtray/beverage holder.
    • Remove the upper screws.
    • Remove the ashtray/beverage holder.
    Fig 3: Identifying Ashtray/Beverage Holder And Screws
    GF0005263Courtesy of FORD MOTOR CO.
  5. Remove the instrument panel center finish panel.
    • Remove the 5 screws.
      • Four screws if equipped with manual transmission or manual four wheel drive (4WD).
    • Remove the instrument panel center finish panel.
    • Disconnect the electrical connector.
    Fig 4: Identifying Instrument Panel Center Finish Panel And Screws
    GF0005264Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals