Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of injury in collisions.

Remove the cap from the safety belt buckle nut.

Fig 1: Identifying Safety Belt Buckle Cap
Courtesy of FORD MOTOR CO.
Remove the nut and the safety belt buckle.
- To install, tighten to 55 Nm (41 lb-ft).
Fig 2: Identifying Safety Belt Buckle Nut
Courtesy of FORD MOTOR CO.
Remove the cap from the safety belt nut.
Remove the nut and the safety belt tongue.
- To install, tighten to 55 Nm (41 lb-ft).
Fig 3: Identifying Safety Belt Tongue
Courtesy of FORD MOTOR CO.

NOTE: Make sure the safety belt webbing is not twisted prior to installation.

NOTE: Make sure the safety belt is positioned in the retaining straps.

To install, reverse the removal procedure.
Check the active restraint system for correct operation. For additional information, refer to Safety Belt System in this article.