LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 817 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat - Rear, 60/40, CrewCab >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: New bolts must be installed, do not reuse the bolts that were removed. The studs and nuts can be reused.
  1. Remove and discard the rear seat load floor-to-floor bolt.
    • To install, tighten to 62 Nm (46 lb-ft).
  2. Remove the 6 load floor bolts and remove the load floor assembly.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Remove and discard the 3 front seat riser-to-floor bolts.
    • To install, tighten to 62 Nm (46 lb-ft).
  4. Remove the 2 rear seat riser-to-floor nuts and bolt.
    • To install, tighten to 62 Nm (46 lb-ft).
    5. NOTE: Removing the rear seat requires more than one technician.
  5. Remove the 60/40 rear seat assembly.
  6. To install, reverse the removal procedure.
    • Make sure the safety belt is not twisted prior to installation.
    • Make sure the safety belts and buckles are accessible to the occupants after installation.
scientia non olet · About LEMON Manuals