Seat Cushion - Front, 20 Percent: Assembly

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Position the seat cushion foam pad on the pan. Fasten the J-clips.

Fig 1: Identifying Seat Cushion Foam Pad J-Clips
Courtesy of FORD MOTOR CO.

NOTE: LH shown, RH similar.

Fig 2: Locating RH And LH Seat Riser Retaining Bolts

Courtesy of FORD MOTOR CO.

Install the RH and LH seat riser retaining bolts.
- To install, tighten to 50 Nm (37 lb-ft).
Install the LH seat back bracket bolts.
- To install, tighten to 50 Nm (37 lb-ft).
Fig 3: Locating LH Seat Back Bracket Bolts
Courtesy of FORD MOTOR CO.
Install the seat latch. For additional information, refer to Seat Latch - 20 Percent in this article.
Install the seat backrest. For additional information, refer to Seat Backrest - Front, 20 Percent in this article.
Install the front seat. For additional information, refer to Seat - Front, 20 Percent in this article.
Install the front seats. For additional information, refer to Seat - Front, With Seat Integrated Restraints (SIR) or Seat - Front, Bucket and 40 Percent in this article.