LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Automatic Transmission External Controls - F250-F550) >> General Procedures >> Selector Lever Indicator Adjustment

Selector Lever Indicator Adjustment

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper instrument panel steering column cover.
  2. Place the selector lever in the Overdrive (Circle D) position.
    • Rotate the selector lever clockwise until it bottoms out (1ST gear). Rotate the lever 3 detents counterclockwise (D) for the TorqShift transmission.
  3. Center the pointer in the middle of the Overdrive (Circle D) position.
    • Rotate the thumbwheel located on the bottom of the steering column to adjust the pointer.
    Fig 1: Locating Overdrive (Circle D) Position
    GF0007078Courtesy of FORD MOTOR CO.
  4. Carefully move the selector lever from detent to detent and compare with transmission settings. Readjust if necessary.
  5. Install the upper instrument panel steering column cover.
scientia non olet · About LEMON Manuals