Selector Lever Cable Adjustment

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Place the selector lever in the Overdrive (Circle D) position.
Position the vehicle on a hoist. For additional information, refer to JACKING AND LIFTING article.
Disconnect the transmission selector lever cable from the manual lever.

Fig 1: Locating Transmission Selector Lever Cable
Courtesy of FORD MOTOR CO.
Unlock the lock tab on the transmission selector lever cable.

Fig 2: Unlocking Lock Tab On Transmission Selector Lever Cable
Courtesy of FORD MOTOR CO.
Place the manual control lever in the Overdrive (Circle D) position.
- Place the manual control lever in the 1ST gear position.
- Move the manual control lever 3 detents to the (D) position.
Fig 3: Moving Manual Control Lever
Courtesy of FORD MOTOR CO.
Connect the transmission selector lever cable to the manual lever.

Fig 4: Locating Transmission Selector Lever Cable
Courtesy of FORD MOTOR CO.
Lock the transmission selector lever cable lock tab.

Fig 5: Locking Transmission Selector Lever Cable Lock Tab
Courtesy of FORD MOTOR CO.
Carefully move the selector lever from detent to detent and compare with transmission settings. Verify that the vehicle will start in PARK or NEUTRAL and backup lamps illuminate in REVERSE. If not, Steps 1-5 must be repeated and include digital TR or TR position sensor adjustment in NEUTRAL. Readjust if necessary.