LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 799 (Steering System - General Information - F250-F550) >> Diagnostic Tests >> Steering System >> Component Tests >> Steering Gear Valve Test

Steering Gear Valve Test

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in motion, place the transmission in NEUTRAL and turn the engine OFF.
    • If the vehicle does not pull with the engine OFF, install a new steering gear. Refer to POWER STEERING article.
  2. If the vehicle pulls with the engine OFF, switch the right side front wheel to the left side of the vehicle and the left side front wheel to the right side of the vehicle.
  3. If the vehicle pulls to the opposite side, switch the front wheels with the rear wheels keeping them on the same side of the vehicle.
  4. If the vehicle pull direction does not change, check the front suspension components, wheel alignment and frame alignment. Refer to the appropriate Suspension article for the procedure.
scientia non olet · About LEMON Manuals