LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 793 (Engine System - General Information - F250-F550 (Gasoline)) >> General Procedures >> Crankshaft End Play

Crankshaft End Play

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools

Illustration Tool Name Tool Number
GF0000024
 Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent
  1. Measure the crankshaft end play. Use a Dial Indicator Gauge with Holding Fixture to measure crankshaft end play.
  2. Position the crankshaft to the rear of the cylinder block.
  3. Zero the indicator.
  4. Move the crankshaft to the front of the cylinder block. Note and record the crankshaft end play.
    • If crankshaft end play exceeds specifications, install a new crankshaft thrust washer or crankshaft thrust main bearing. Refer to the appropriate Engine article for the procedure.
    Fig 1: Measuring Crankshaft End Play
    GF0000184Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals