LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 787 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Throttle Position (TP) Sensor - 6.8L >> Removal

Throttle Position (TP) Sensor - 6.8L: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the throttle position (TP) sensor electrical connector.
    2. CAUTION: Failure to remove the throttle position (TP) sensor screws in the following manner will result in damage to the screws. First loosen the screws 1-2 full turns using a hand tool and then use a suitable high speed driver to complete the removal.
  2. Remove and discard the 2 screws and the TP sensor.
scientia non olet · About LEMON Manuals