Starter Motor: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Position the starter motor and install the 3 bolts in 3 stages.
- Stage 1: Install the 3 bolts finger tight.
- Stage 2: Tighten the upper bolt to 25 Nm (18 lb-ft).
- Stage 3: Tighten the 2 lower bolts to 25 Nm (18 lb-ft).
Connect the starter wiring.
- Tighten the cable to 12 Nm (9 lb-ft).
- Tighten the wire to 6 Nm (53 lb-in).

Fig 1: Locating Starter Mounting Bolts

Courtesy of FORD MOTOR CO.

Install the starter solenoid protective cap.

Fig 2: Identifying Starter Motor Solenoid Protective Cap

Courtesy of FORD MOTOR CO.

Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.