LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 774 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Slip Yoke >> Disassembly

Driveshaft Slip Yoke: Disassembly

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driveshaft from the vehicle. For additional information, refer to Driveshaft - Front  or Driveshaft - Rear, One-Piece, Four Wheel Drive (4WD)  in this article.
    2. NOTE: Do not clamp the driveshaft in the jaws of a vise or a similar holding fixture.
  2. Place the driveshaft on a suitable workbench.
  3. Index-mark the driveshaft slip yoke and the stub shaft.
    4. Fig 1: Locating Index-Mark Driveshaft Slip Yoke And Stub Shaft
    GF0006287Courtesy of FORD MOTOR CO.
  4. Remove the driveshaft slip yoke.
    • Cut and discard the 2 driveshaft slip yoke boot clamps.
    • Separate the driveshaft slip yoke from the stub shaft.
    5. Fig 2: Removing Driveshaft Slip Yoke
    GF0006288Courtesy of FORD MOTOR CO.
  5. Remove and discard the driveshaft slip yoke boot.
    6. Fig 3: Removing Driveshaft Slip Yoke Boot
    GF0006289Courtesy of FORD MOTOR CO.
  6. Check the lubricant for contamination. If the lubricant feels gritty, clean and inspect the stub shaft and driveshaft slip yoke for wear. Install new components as necessary.
    7. Fig 4: Inspecting Stub Shaft And Driveshaft Slip Yoke
    GF0006290Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals